SC-6101

Summary

Product identification

• Model: SC-6101
• Description: High rejection and chlorine resistant RO element
• Membrane Type: Modified Cellulose Acetose
• Element Configuration: Spiral Wound

Performance Specification

• Salt Rejection: 98.0 % (97.0 % minimum*)
• Product Flow Rate: 5.3 m³/day (1400 gpd) (4.3 m³/day (1130 gpd) minimum*)
  • *For any single element

Test Conditions

• Feed Water Pressure: 3.0 MPa (440 psi)
• Feed Water Temperature: 25 °C (77 °F)
• Feed Water Concentration: 1500 mg/L as NaCl
• Brine Flow Rate: 20 L/min (5.3 gpm)
• Feed Water pH: 6

Operating Limits

• Design Conditions (Recommended):
  • Feed Water Pressure: 30 kg/cm² (430 psi)
  • Feed Water Temperature: 30 °C (86 °F)
  • Feed Water Turbidity (SDI): 4 (Note: High flux operation on feed water turbidity greater than 3 or 4 SDI generally results in frequent cleaning requirements.)
  • Feed Water Chlorine Concentration: 0.1 - 0.7 mg/L
  • Feed Water pH Range (Continuous Operation): 4 - 6.5
  • Feed Water pH Range (Chemical Cleaning): 3 - 8.5
  • Feed Flow Rate per Vessel: 45 L/min (11.9 gpm)
  • Brine Flow Rate per Vessel: 10 L/min (2.6 gpm)
  • Brine/Permeate Flow Ratio: 6 (Note: This figure is reducible when there is less possibility of fouling and scaling.)
• Maximum Feed Water Pressure: 4.1 MPa (600 psi)

Feed water

• Refer to "Performance Specification - Test Conditions" and "Operating Limits - Design Conditions" for detailed parameters.
• SDI = Silt Density Index measured according to ASTM D4189.
• Feed and brine water must meet the specified ranges.

Product water

• Refer to "Performance Specification" for detailed parameters.

Mechanical / hydraulic

• Dimensions:
  • Length: 1016 mm
  • Outer Diameter: 101 mm
  • Permeate Tube Nominal Diameter: 15 mm
  • All dimensions shown in millimeters.
• Pressure Drop:
  • Per Element: 0.10 MPa (14 psi)
  • Per Vessel: 0.20 MPa (29 psi) (Note: Element(s) must be cleaned when pressure drop increases up to 1.5 times of initial value.)

---

Disclaimer: This summary is generated from extracted text and may not include all figures, footnotes, or the latest revisions present in the official PDF datasheet. For contractual data, please refer to the specific OEM PDF revision used on your project.

Official datasheet (PDF)

PDF datasheet