PolyFloc CE1161P

Summary

Product identification

PolyFloc CE1161P

Description and use

• Cationic, polymeric, low charge density, high molecular weight flocculant.
• Designed for industrial treatment programs as a coagulant aid or flocculant.
• Used in clarification, thickening, and sludge dewatering processes.
• NSF-certified for potable applications up to 3 mg/L (ppm).
• Liquid emulsion, cost-effective for solids separation in influent and effluent water treatment.
• Produces a fast-settling floc, reducing carryover in clarifiers.
• Effective at lower pH in conjunction with a coagulant in influent clarifiers and paper mill primary wastewater clarifiers.
• Provides cost-effective sludge conditioning for primary, oily, and paper industry sludges.
• Results in clean filtrate, high solids capture, and drier cake, leading to lower transportation and disposal costs.

Treatment and feeding requirements

• Must be dissolved in water before use.
• Prepare solution by slowly adding polymer to the vortex of an agitated tank; do not add water to neat polymer.
• Recommended initial makedown solution concentration: 0.5% (range 0.3 to 1%).
• Use low-speed (350 rpm) mechanical agitation for complete dissolution.
• Avoid high shear or excessive agitation once dissolved.
• Diluted solutions recommended for use within 24 hours for maximum activity.
• Continuous makedown systems are available for more reliable results.
• Further dilution to approximately 0.1% enhances performance in most applications.
• For dewatering applications, dilution to approximately 0.25% may be more practical.
• Diluted product can be fed by pump, eductor, or gravity flow to a point of good mixing (not violent agitation).
• High-speed mixing decreases polymer activity.
• Transfer pumps should be positive displacement gear or piston pumps.
• Liquid-side components: stainless steel or most plastics (except LD polyethylene and polypropylene). Mild steel acceptable only if corrosion product contamination is not critical.
• Pump components and hose linings: Viton and Tygon rubbers are acceptable.

General properties

Physical properties are shown on the Material Safety Data Sheet.

Packaging information

Available in a variety of containers as a liquid emulsion product.

Storage and handling

• Store at moderate temperatures of 45 to 95°F (7 to 35°C).
• Protect from freezing. If frozen, thaw completely and mix thoroughly before use.
• Bulk containers should be insulated and heat traced if stored outdoors.
• Neat polymer should be recirculated or mixed periodically to avoid product separation (recirculate one container volume per day).
• Spilled polymer is very slippery.
• Small spills: wash down with copious amounts of water.
• Large spills: contain, absorb on inert material, dispose as solid waste, then flush with water.

Safety precautions

A Material Safety Data Sheet with detailed information is available on request.

---

Disclaimer: This extraction may miss figures, footnotes, or revisions. Contractual data must match the OEM PDF revision used on the project.

Official datasheet (PDF)

Lenntech datasheet mirror